![]() Setup SSO with Azure Active Directory Portal is somewhat easier. (This is MFA GUID for everyone globally)Ĭ: Set-AdfsAzureMfaTenant -TenantId -ClientId 981f26a1-7f43-403b-a875-f8b09b8cd720ĭ: Open Registry Editor on the AD FS server.Į: Navigate to HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\ADFS. We support both SAML 2.0 via self hosted ADFS and Azure AD. ClientĪ: Connect-msolservice (Connect to MSOL PowerShell)ī: New-MsolServicePrincipalCredential -AppPrincipalId 981f26a1-7f43-403b-a875-f8b09b8cd720 -Type asymmetric -Usage verify -Value $certBase64ĩ81f26a1-7f43-403b-a875-f8b09b8cd720 is the GUID for Azure Multi-Factor Auth. Set the certificate as the new credential against the Azure Multi-Factor Auth. Do the following using PowerShell to add the new credentials to the Azure Multi-Factor Auth Client Service Principal. The certificates generated using the New-AdfsAzureMFaTenantCertificate cmdlet will serve as these credentials. Client, you need to add the credentials to the Service Principal for the Azure Multi-Factor Auth Client. To enable the AD FS servers to communicate with the Azure Multi-Factor Auth. On the Add Transform Claim Rule Wizard, select Pass Through or Filter an Incoming Claim from the drop-down and click Next. On Issuance Transform Rules, click Add Rule. Right-click on Microsoft Office 365 Identity Platform and select Edit Claim Rules. Table 4 - WAP and Federation Servers This table describes the ports and protocols that are required for communication between the Federation servers and WAP servers. On the left, select Relying Party Trusts. Tenant GUID can get by going to Azure AD portal > Overview : Step 2: Add the new credentials to the Azure Multi-Factor Auth. This table describes the ports and protocols that are required for communication between the Azure AD Connect server and AD FS Federation/WAP servers. The certificate can be found under certificate console. ![]() ![]() ![]() $certbase64 = New-AdfsAzureMfaTenantCertificate -TenantID The first thing you need to do is generate a certificate for Azure MFA. Step 1: Generate a certificate for Azure MFA on each AD FS server using the New-AdfsAzureMfaTenantCertificate cmdlet Make sure steps required to be performed on all AD FS servers in the farm: To resolve the above error, followed below steps. MFA was not getting prompted while logging in to RDS and giving error: ![]()
0 Comments
Leave a Reply. |